Purchase PAIR of Genuine Suzuki DRZ400 / LTZ400 INTAKE VALVES part

Z400 Valve Clearance. LTZ400/KFX400/DVX400 Running Lean READ THIS Suzuki Central Forum All 4 cam caps are marked .10 from factory.why would factory set all at .10 ?which is lower end of intake spec Valve Clearance Adjustment Refer to the Valve Clearance Adjustment in the Periodic Maintenance chapter

Valve Removal Remove: Cylinder Head (see Cylinder Head Removal) Valve Lifter and Shim Mark and record e valve lifter and shim locations so they can be installed in their original positions. At every service, change the oil and do a general inspection

Original Mopedbilsdelar > Engines > Kubota > Kubota engine Z402

Z400 Valve Clearance & Torque specs 03-04 LT-Z400 Valve clearance Cold engine, set at TDC. Z400 Valve Clearance & Torque specs 03-04 LT-Z400 Valve clearance Cold engine, set at TDC. Valve Clearance Inspection Refer to the Valve Clearance Inspection in the Periodic Maintenance chapter

AHL 9.48 mm Valve Adjustment Shims Valve Pad Shims Hotcam For SUZUKI. Check the intake and exhaust valve clearances at the distances indicated above and adjust the valve clearances to specification, if necessary. Valve Clearance Inspection Refer to the Valve Clearance Inspection in the Periodic Maintenance chapter

Valve Clearance Check and Adjustment. All 4 cam caps are marked .10 from factory.why would factory set all at .10 ?which is lower end of intake spec You can do this before putting the cam chain tensioner back by just sticking your finger in the CCT hole and pressing in on the guide while you rotate the motor over one full rev